The forecast is for scattered showers turning to snow in the late afternoon. If I start the fire an hour earlier, maybe the turkey will be ready by 3:00…probably not.
We have always cooked our turkey on the grill. Early on we had a couple of occasions where we were tempted to just go ahead and cook inside, but we always stuck to our guns and did the barbecue. Even after we moved from sunny California to New York we have stayed with our tradition. It isn’t just stubbornness on our part- the flavor and texture is worth the extra effort.
A chimney is the best way to start the charcoal- no lighter fluid, just a sheet of newspaper…or two or three.
The coals are divided on each side of the kettle and a small roasting pan is placed in the middle to catch the drippings. A layer of water helps keep the drippings from scorching.
We try to have a 20 pound turkey to cook. We like the leftovers, so a smaller bird doesn’t seem worthwhile. More than 24 pounds and fit in the Weber becomes an issue. We don’t stuff the turkey- the cooking time gets too long and it is hard not to have over-cooked areas. While the charcoal is starting the turkey gets dried inside and out. I spray PAM all over the outside of the turkey, then sprinkle well with garlic salt. I also stick slivers of garlic under the skin all around the breast side of the bird.
A layer of foil protects the skin so that it doesn’t brown before the meat cooks. The wings and legs each get a block of foil (the oil spray helps prevent the skin from sticking to the foil).
A sheet of foil goes on the grill with holes pierced in it to let the juices drip into the pan. The turkey get set on the foil (this may take two people on a breezy day) and the sides tucked up to cover up to the foil on the legs and wings.
A length of foil goes overt the breast and upper edges of the other foil pieces to finish wrapping the turkey.
The turkey gets a protective wrapping of foil in sections so that it can be unwrapped as it finishes cooking. The heat and smoke can work its way through the layers of foil, but the skin doesn’t scorch. Once the turkey is on the grill and covered, the lid goes on with the vent facing into the wind to help the heat circulation.
Cold wind, especially with rain or snow, draws heat from the Weber very quickly. A sheltered location can help cut heat loss.
In warmer weather the turkey will be able to completely cook with one load of charcoal. That doesn’t happen in November in New York, however. I’m finding that it is best to start another chimney of briquettes (about 20 or so) after the turkey has been cooking about an hour. Once they are going good, split them between the two stacks that have been cooking.
When the meat temperature gets to the 160° range it is time to start unwrapping the bird to start browning. The breast cover comes off first, the legs get exposed once the color starts developing. The wings stay covered- they are thin and will overcook very easily.
When the meat temperature gets to 160° I start trying to estimate when the bird will come off of the grill. Checking the temperature change in 5 minutes gives me a rough idea how much time is left to cook- helpful to coordinate the rest of the meal. It also lets me know if the charcoal stalls, which happens with a wind or precipitation increase or the coals are burning out. I use a digital probe on a braided lead, so I don’t have to lift the lid to check the temperature- opening the lid drops the temperature and extends the time.
Once the turkey reaches 178 or so I start getting ready to pick it up. The temperature will come up a couple of degrees while the bird rests on the counter. I let turkey rest 10 to 15 minutes before carving so the juices stay in the meat. It is after 4:00, so we are running a bit late, but there are only mild complaints. The flavor of the juicy meat makes up for a delayed dinner!
Finally! The meat is up to temperature- time to bring the turkey to the feast!
Snowy Outlet Trail
I took advantage of a beautiful sunny day to walk part of the Outlet Trail with my daughter Katie. We found quite a few folks with the same idea- some on skis, some on snowshoes, a few in hiking boots. We started at the Seneca Mills site and walked a bit along the stream toward Penn Yan. We both had cameras, so we took our time and enjoyed the nice sunlight. Katie’s pictures can be found at Keuka Outlet Trail – Kathryn Mae Photography.
A good snow cover for cross-country skiers and snowshoes, the trail still had easy footing for walking.
Snow, Ice and water define the double falls alongside the Seneca Mills ruins.
While some of the Mills walls have collapsed into the stream, some are still in good condition.
Wild raspberry canes show maroon against a snowy background.
Cross-country skiers enjoy a nice snow cover on the Outlet Trail.
Lichens and moss cover stone blocks near Lock 7 of the old canal.
In some ares of the Outlet Trail the old canal is a bog and the trail is the former tow-path. At Lock 7 the trail follows the canal bed.
I took several pictures of the Outlet Stream and the Falls from the structure of the Seneca Mills water handling controls, then stitched them together to make this panorama.
Apple Cider Syrup
Here is a nice step up from a 2 gallon pot on our stove- a 60 gallon steam jacketed kettle!
We have made Apple Cider Syrup for our guests for several years, but have not been able to make syrup for outside sales under our permit with Ag & Markets. We have toyed with the idea of making a commercial kitchen, but other projects keep popping up. In December we met Joe Mullaney from Glen Industries, a division of The Arc of Schuyler that does food co-packing. After a tour of their kitchen we realized that they could produce in a few hours what would take days in any kitchen we could build. We supply the materials and our recipe, and they do the rest!
Our first batch was made this week. We raced up to Medina on Tuesday to get cider fresh from the press, and delivered it to Glen Industries with all the other ingredients. Early Thursday I arrived to oversee the syrup production. Joe and the kitchen supervisor Chad were all set to get things rolling.
Something else we don’t have in our kitchen- a 5 foot whisk!
The batch handled a lot like the small batches we do at home- just much bigger quantities. Ingredients that were tablespoons turn into pounds, cup measures become hundred pounds. Joe and Chad have a set of huge wire whisks that stir out the lumps just like at home, only with two hands and some muscles. There is an electric mixer available, but the whisks worked pretty well. The steam heat brought up the temperature on the batch very quickly. However, unlike our gas stove at home, once the pot starts boiling it stays boiling even after the heat is reduced.
Pouring hot syrup into a tub to transfer to the filling machine.
The other piece of equipment that is a huge time saver is the filling machine. The syrup is loaded into a hopper, and preset amounts are measured into the bottles. Workers set the bottle under the nozzle and press a foot switch and the bottle is filled and ready to go to the capper. Another worker twists on the cap and makes sure the bottle is clean (when working with syrup, sticky happens). After the bottles cool the labels and safety seals will be applied.
Maybe you have to spend some time ladling hot syrup into a funnel to fill jars to truly appreciate how great an improvement the filling machine is!
All told, it took a bit over 3 1/2 hours to make and bottle over five hundred jars of syrup. In our home process it would take two or three long days to get to the same point. Joe and his crew did a great job, and we hope to have them making more syrup in the near future!
Thanksgiving Barbecue
The forecast is for scattered showers turning to snow in the late afternoon. If I start the fire an hour earlier, maybe the turkey will be ready by 3:00…probably not.
We have always cooked our turkey on the grill. Early on we had a couple of occasions where we were tempted to just go ahead and cook inside, but we always stuck to our guns and did the barbecue. Even after we moved from sunny California to New York we have stayed with our tradition. It isn’t just stubbornness on our part- the flavor and texture is worth the extra effort.
A chimney is the best way to start the charcoal- no lighter fluid, just a sheet of newspaper…or two or three.
The coals are divided on each side of the kettle and a small roasting pan is placed in the middle to catch the drippings. A layer of water helps keep the drippings from scorching.
We try to have a 20 pound turkey to cook. We like the leftovers, so a smaller bird doesn’t seem worthwhile. More than 24 pounds and fit in the Weber becomes an issue. We don’t stuff the turkey- the cooking time gets too long and it is hard not to have over-cooked areas. While the charcoal is starting the turkey gets dried inside and out. I spray PAM all over the outside of the turkey, then sprinkle well with garlic salt. I also stick slivers of garlic under the skin all around the breast side of the bird.
A layer of foil protects the skin so that it doesn’t brown before the meat cooks. The wings and legs each get a block of foil (the oil spray helps prevent the skin from sticking to the foil).
A sheet of foil goes on the grill with holes pierced in it to let the juices drip into the pan. The turkey get set on the foil (this may take two people on a breezy day) and the sides tucked up to cover up to the foil on the legs and wings.
A length of foil goes overt the breast and upper edges of the other foil pieces to finish wrapping the turkey.
The turkey gets a protective wrapping of foil in sections so that it can be unwrapped as it finishes cooking. The heat and smoke can work its way through the layers of foil, but the skin doesn’t scorch. Once the turkey is on the grill and covered, the lid goes on with the vent facing into the wind to help the heat circulation.
Cold wind, especially with rain or snow, draws heat from the Weber very quickly. A sheltered location can help cut heat loss.
In warmer weather the turkey will be able to completely cook with one load of charcoal. That doesn’t happen in November in New York, however. I’m finding that it is best to start another chimney of briquettes (about 20 or so) after the turkey has been cooking about an hour. Once they are going good, split them between the two stacks that have been cooking.
When the meat temperature gets to the 160° range it is time to start unwrapping the bird to start browning. The breast cover comes off first, the legs get exposed once the color starts developing. The wings stay covered- they are thin and will overcook very easily.
When the meat temperature gets to 160° I start trying to estimate when the bird will come off of the grill. Checking the temperature change in 5 minutes gives me a rough idea how much time is left to cook- helpful to coordinate the rest of the meal. It also lets me know if the charcoal stalls, which happens with a wind or precipitation increase or the coals are burning out. I use a digital probe on a braided lead, so I don’t have to lift the lid to check the temperature- opening the lid drops the temperature and extends the time.
Once the turkey reaches 178 or so I start getting ready to pick it up. The temperature will come up a couple of degrees while the bird rests on the counter. I let turkey rest 10 to 15 minutes before carving so the juices stay in the meat. It is after 4:00, so we are running a bit late, but there are only mild complaints. The flavor of the juicy meat makes up for a delayed dinner!
Finally! The meat is up to temperature- time to bring the turkey to the feast!